HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: [hylafax-users] Waiting for Modem to come ready


Lee Howard wrote:

> What version of HylaFAX


> (where did you get it)

HylaFAX web site

> and what OS?

Red Hat 6.2 standard kernel.

It is plugged into an add-in PCI I/O card, in a Compaq Prosignia 200, which I
configured using setserial and data from /proc/pci as follows:

/proc/pci reports the following:

  Bus  0, device  10, function  0:
    Serial controller: Unknown vendor Unknown device (rev
      Vendor id=9710. Device id=9835.
      Medium devsel.  Fast back-to-back capable.  IRQ 3.
      I/O at 0x5450 [0x5451].
      I/O at 0x5458 [0x5459].
      I/O at 0x5460 [0x5461].
      I/O at 0x5468 [0x5469].
      I/O at 0x5470 [0x5471].
      I/O at 0x5440 [0x5441].

I used the following setserial command:

setserial /dev/ttyS1 port 0x5450 UART 16550A IRQ 3 baud_base

The command seems to work and a setserial /dev/ttyS1 -a

/dev/ttyS1, Line 1, UART: 16550A, Port: 0x5450, IRQ: 3
        Baud_base: 115200, close_delay: 50, divisor: 0
        closing_wait: 3000, closing_wait2: infinte
        Flags: spd_normal skip_test

I can connect to the modem using cu -l /dev/ttyS1 -s 38400

Ken Cole
Satisfaction Software
e-mail: ken@satsof.com.au
Voice: +61 7 3268 4722
Facsimile: +61 7 3268 4359
Mobile: 0418 792 349

____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null

Project hosted by iFAX Solutions