HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

[hylafax-users] Hylafax and PABX


I've installed HylaFax on FreeBSD 4.2-STABLE and it works fine, but
I'm not able to configure it when it runs from a internal line
where there is a PABX.
I got the message: no local dial tone.

Some other times I've got no message but the server doesn't dial at

I've tried to insert ATX3 into some fax/etc/cuaa1.config:
ModemHardFlowCmd:	ATX3:	AT&K3		# hardware flow control cmdK3
ModemSoftFlowCmd:	ATX3:	AT&K4		# software flow control cmdK4
ModemSetupDTRCmd:	ATX3:	AT&D3		# DTR off causes modem to resetD3
#ModemSetupDTRCmd:	AT&D2S25=1S38=0	# Dynalink 1414VE needs this
ModemSetupDCDCmd:	ATX3:	AT&C1		# DCD follows carrierC1
ModemSetupAACmd:	ATX3+FAA=1+FCLASS=0

But it seems get not effect.

Please give me some suggestions.

(Hylafax version 4.1.b2)

Thank you in advance,                   \fer

____________________ HylaFAX(tm) Users Mailing List _______________________
 To unsub: mail -s unsubscribe hylafax-users-request@hylafax.org < /dev/null

Project hosted by iFAX Solutions