HylaFAX The world's
most advanced open source fax server
Re: [hylafax-users] No carrier detected
On 2004.03.04 08:22 Steven Kurylo wrote:
Again, try Class 1.
Well now this has gone to pot. Now no matter what I do I get "No
carrier detected" in any class I try. I've rebooted and nothing
I haven't figured out why yet, but class one detection fails with
faxaddmodem (2.0 and 2.1 are fine), mawk returns a regex error.
Its line 1075: (C == $4 || (C ~ $4 && $4 ~ "*")) && I ~ $5 && F ~ $6
The part $4 ~ "*" is failing. If I delete the && $4 ~ "*"
faxaddmodem works fine, it uses the lucent config. I'm not sure
what the problem is, I can look into it further once I figure out why
I can send faxes anymore. Faxaddmodem says the modem is
So back to the "No carrier detected"; I tried to dial the number of
the line the modem is hooked up to, and I got the same message, I
should have got a busy message. So I turned the modem's volume up
and listened. I've never listened to the modem before, but I'm sure
its not sounding right. On other modems I could hear the pitch
difference while the modem was dialing. Now I just hear the same
tone for each number dialed (it doesn't matter where I call). Then
it makes a sound that should be a ring, but its the same tone at the
(time) frequency of a normal ring. The number I'm dialing never
receives a call.
Defective modem, probably.
____________________ HylaFAX(tm) Users Mailing List _______________________
To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
*To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxxxxx*