HylaFAX The world's
most advanced open source fax server
Re: [hylafax-users] High Error Rates still
On 2004.07.30 12:44 Stephen Carville wrote:
Currently I am using:
ttyS0: 56K External Modem Venus V.92 (69% of trafffic)
ttyS4: USRobotics Courier V.Everything (28% of traffic)
ttyS5: USRobotics Courier V.Everything (3% of traffic)
(These are modems that were lying around the shop and some are pretty
All are configured as class 1
> What version of HylaFAX are you using?
> What are the typical receiving errors that you see?
Among the more popular ones:
Unspecified Phase C error, including too much delay between TCF and
This error message can only occur in Class 2/2.0/2.1. So, on which
modems are you running Class 2/2.0/2.1?
T.30 T2 timeout, expected page not received
Teh most popular error is sometinhg like:
RECV: 123 total lines, 85 bad lines, 13 consecutive bad lines
RECV: REJECT page quality, 30% good lines (95% required)
This particular fax was resent about 2 minutes later with similar
RECV: 123 total lines, 84 bad lines, 12 consecutive bad lines
RECV: REJECT page quality, 31% good lines (95% required)
Well, off-hand I can't say anything other than what that error message
says. If you showed the whole log then maybe I could help more, but I
think that the conclusion would be the same:
Upgrade to 4.2.0 and see how you fare. Make sure that you run Class 1
or Class 1.0.
____________________ HylaFAX(tm) Users Mailing List _______________________
To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi
On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null
*To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*