HylaFAX The world's most advanced open source fax server

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: [hylafax-users] modem config for apple USB modem


On 2007/10/13, at 2:20, Lee Howard wrote:

Yoshi wrote:

Oct 12 10:56:55.17: [   86]: SESSION BEGIN 000000013 ***********
Oct 12 10:56:55.17: [   86]: HylaFAX (tm) Version 4.4.0
Oct 12 10:56:55.17: [   86]: <-- [4:ATA\r]
Oct 12 10:57:02.43: [   86]: --> [7:CONNECT]
Oct 12 10:57:06.46: [   86]: --> [5:ERROR]
Oct 12 10:57:06.46: [   86]: MODEM Command error
Oct 12 10:57:06.46: [   86]: ANSWER:
Oct 12 10:57:06.46: [   86]: SESSION END

The *only* case in which ATA should result in error would be if, according to T.31...

"if five seconds elapses from the time when the DCE reported the CONNECT result code without any additional data transmitted from the DTE"

This would require a HylaFAX problem. Your logging level is not sufficient to see if it is HylaFAX at fault here. Please set ServerTracing to 0xFFF immediately preceded by "TracingMask: 0" in your modem config file, restart faxgetty, and try again. Then show me the session log.



I tried AT commands written on modem config file on 'minicom', there occured an error by: AT+FAA=1

It was declared as:
ModemSetupAACmd:       AT+FAA=1

So I commented out that and call to mac, but log has not changed.


(modem config: config.tty.usbmodem)
ModemType: Class1 # use class 1 interface
ModemRate: 19200 # locked for fax sending&receiving
ModemFlowControl: rtscts # default
ModemNoFlowCmd: AT\Q # disable flow control cmd
ModemSoftFlowCmd: AT&R1\Q1 # software flow control cmd
ModemHardFlowCmd: AT&R\Q3 # hardware flow control cmd
ModemSetupDTRCmd: AT&D3 # DTR off causes modem to reset
ModemSetupDCDCmd: AT&C1 # DCD follows carrier
ModemSetupAACmd: AT+FAA=1
ModemAnswerCmd: "ATA\r"
ModemWaitForConnect: yes # modem sends FAX/DATA first
ModemMfrQueryCmd: !Motorola
ModemModelQueryCmd: !28.8
ModemRevQueryCmd: AT%V # model and firmware rev
ModemDialCmd: ATDT%s # T for tone dialing


____________________ HylaFAX(tm) Users Mailing List _______________________ To subscribe/unsubscribe, click http://lists.hylafax.org/cgi-bin/lsg2.cgi On UNIX: mail -s unsubscribe hylafax-users-request@xxxxxxxxxxx < /dev/null *To learn about commercial HylaFAX(tm) support, mail sales@xxxxxxxxx*

Project hosted by iFAX Solutions